Pg. 26 80231-EN-V2025-02-14
Push this button at anytime to STOP the workout. If in PAUSE state, push the STOP button to end a
paused workout and enter IDLE state.
Press 2, 4, 6, or 8 INCLINE preset button to directly move to that INCLINE
seconds to quickly change the INCLINE.
Press 2, 4, 6, or 8 SPEED preset button to directly move to that SPEED. Use the
seconds to quickly change the SPEED.
Back icon
The default speed and distance units are mph / miles, but can be set to kph / km. To change the
units of measurement with the Touchscreen Console, tap on SETTING (lower right corner of the
display) from the IDLE mode. Then tap on Machine Setting, and Unit. The option for Imperial or
Metric is displayed. Tap on the desired unit of measurement, and then tap the Back icon to exit to
the IDLE mode.
CONSOLE MODES
After the On/Off power switch is turned on, the Touchscreen Console will start up
and show the Log In screen after approximately 40 seconds. All segments and icons on the Console
Keypad will also light up for 2 seconds, then it will enter IDLE mode.
30 seconds. After 5 more minutes of no activity, the backlight will flash Green for 30 seconds and all of the
Console Keypad lights will turn off.
If Sleep mode is active under Machine Settings on the Touchscreen
Console, the treadmill will enter LOW POWER CONSUMPTION mode after 10 minutes of no activity. This
mode is to save power when not using the treadmill. During LOW POWER CONSUMPTION mode, a
maximum of 0.46 Watts is used by the treadmill. Push any button on the Console Keypad to exit LOW
POWER CONSUMPTION mode and shift to IDLE mode.
In PAUSE mode, the INCLINE and SPEED with both be set to 0. Push START / PAUSE button to
resume workout, and STOP to end your workout and enter IDLE mode. The workout will resume, and speed
and incline will gradually return to the levels when the workout was paused.
When in IDLE mode, press the START / PAUSE button to begin a Quick Start Workout, or select
a workout program from the Touchscreen Console. The console will do a 4 second countdown and then the
belt will begin to move at the minimum SPEED of 1.0 mph. Press the PAUSE button to enter PAUSE mode,
and the STOP button to end your workout.
After 1 minute, if the belt is moving and the motor does not detect a user on the belt, it will
automatically exit RUNNING mode and enter IDLE mode.
To Next Page