Central Boiler Fire Star - Wi-Fi and Software Configuration; Wi-Fi Enabled Setting; Wi-Fi Configuration Process; Software Update Option

13
FIRESTAR COMBUSTION CONTROLLER - VERSION 6.7 • OPERATION MANUAL
Menu # Setting DEFAULT Min. Max.
8 WI-FI ENABLED
After conguration has been performed, use this menu item to disable (or
enable) the wi- feature without losing your network settings. During a
new installation, proceed directly to menu item #9 to enable wi- for the
rst time.
0 0 1
9 WI-FI ENABLED CONFIGURATION
Setting this to 1 will enable wi- and turn on the conguration network.
This will erase any current wi- settings. When the Connected light turns
blue, nd the Firestar_network on your smartphone; then visit http://
www.wiset.net to congure your network settings.
0 0 1
10 WI-FI WIRELESS N SUPPORT ENABLED
When set to 1, the FireStar will be able to use the 5gz frequency (where
available). May signicantly lower wi- range.
0 0 1
11 SOFTWARE UPDATE OPTION
The FireStar controller has the ability to download and install software
updates through the internet. Take note of the current software version
number before updating by quickly pressing the Power button once.
If required, set this variable to 1 to initiate a software update. A wi-
connection is required (the connected light should be green). During a
software update, furnace operation will stop and the display will ash
special characters to indicate the update process. The entire process should
take about 5 minutes. Do not disconnect power during this process. In
the event of a update failure, BF-4 will be displayed. If an update failure
occurs, turn the FireStar o and back on to restore operation to the
original software version. Repeated update failures may mean that all
available updates are already installed. When an update has completed,
you may need to power the furnace back on. Be sure to take note of the
new software version number and acquire the appropriate documentation
for the new version.
0 0 1
12 WI-FI NETWORK SSID (READ ONLY)
Displays the current wi- network being used by the FireStar. To use a
dierent network, recongure the FireStar using menu item #9.
- - -
13
WI-FI SERIAL NUMBER (READ ONLY)
Displays the serial number of the furnace used during wi-
communication. Typically begins with a letter. An incorrectly entered
serial number can be adjusted by visiting http://myrestar.com/nd on a
smartphone that is attached to the same wi- network as the FireStar.
- - -
14 WI-FI IP ADDRESS (READ ONLY)
Displays the local IP address assigned to your FireStar by your wi- router.
The FireStar must be successfully connected to wi- rst. This is a read
only item--if a static IP is desired, you must set a reservation on your
router by MAC address.
- - -