To Next PageTo Next Page
Need help?Do you have a question about the Central Boiler FireStar and is the answer not in the manual?
Introduces the FireStar controller, its purpose, and basic operation.
Details Purge mode, button actions, fan/air behavior, and LED indications.
Explains using Ignition Assist for starting or re-igniting a fire, air amounts, and duration.
Details the Stop Mode before entering Idle Mode, purging gases, and air actuator actions.
Describes Idle Mode when the water temperature setpoint is reached, and LED display status.
Explains Pulse Mode for maintaining fire during idle, periodic air bursts, and adjustable settings.
Covers turning the controller on/off and adjusting water temperature setpoint.
Describes how to view the flue gas temperature on the LED display.
Explains the procedure to lock or unlock the controller for security.
Steps to enter Setup Mode and change control variables.
States that controller settings are saved during a power outage.
Troubleshooting steps for excessive smoke from the chimney, with recommended actions.
Troubleshooting steps for the fire going out, with recommended actions.
Explains LOW WATER, HIGH TEMP 1/2, and HIGH LIMIT TRIP alarms.
Explains the FIRE OUT alarm, its conditions, and how it is resolved.
Describes the FIRE OUT alarm related to thermocouple failure.
Warning for the firebox door being open and its effect on the purge cycle.
Indicates thermocouple or EPROM memory failures and their consequences.
Section to record wireless network and furnace serial number details.
Step-by-step guide to connect the controller to a Wi-Fi network.
General| Brand | Central Boiler |
|---|---|
| Model | FireStar |
| Category | Controller |
| Language | English |
