Page 3For technical questions, please call 1-800-444-3353.SKU 46149
they can become caught in moving
parts. Wear a protective hair covering
to prevent long hair from becoming
caught in moving parts.
INDUSTRIAL APPLICATIONS MUST 7.
FOLLOW OSHA REQUIREMENTS.
DO NOT OVERREACH. 8. Keep
proper footing and balance at all
times to prevent tripping, falling, and
back injury, etc.
REPLACEMENT PARTS AND 9.
ACCESSORIES. When servicing,
use only identical replacement parts.
Only use accessories intended for
use with this product. Approved
accessories are available from
Harbor Freight Tools.
STAY ALERT. 10. Watch what you are
doing at all times. Use common
sense. Do not use this equipment
when you are tired or distracted from
the job at hand.
CHECK FOR DAMAGED PARTS.11.
Before using this product, carefully
check that it will operate properly
and perform its intended function.
Check for damaged parts and any
other conditions that may affect the
operation of this product. Replace
or repair damaged or worn parts
immediately.
MAINTAIN THIS PRODUCT WITH 12.
CARE. Keep this product clean and
dry for better and safer performance.
MAINTENANCE: 13. For your safety,
service and maintenance should be
performed regularly by a qualied
technician.
USE THE RIGHT PRODUCT FOR 14.
THE RIGHT JOB. There are certain
applications for which this product
was designed. Do not use small
equipment to do the work of larger
industrial equipment. Do not use this
product for a purpose for which it was
not intended.
SPECIFIC PRODUCT WARNINGS
AND PRECAUTIONS
MAINTAIN A SAFE WORK 1.
ENVIRONMENT. Do not use this
product in or near damp or wet
areas. Keep work area oor free of
oil, grease, and other liquids. Do not
expose this product to rain. Keep
work area well lit. Make sure there
is adequate surrounding work space.
Remove all ammable liquids and
objects from the work area. Do not
operate this product in the presence
of ammable liquids, gases, or dust.
DISCONNECT EQUIPMENT FROM 2.
ITS AIR SUPPLY SOURCE AND
RELEASE ALL COMPRESSED
AIR FROM THE SYSTEM BEFORE
PERFORMING ANY SERVICES OR
MAINTENANCE.
NEVER LEAVE THIS PRODUCT 3.
UNATTENDED WHILE
EVACUATING OIL.
NEVER USE THIS EQUIPMENT 4.
NEAR OPEN FLAMES, HEAT OR
IGNITION SOURCES. ALLOW OIL
TO BE EXTRACTED TO COOL
DOWN TO BETWEEN 70-80° F
BEFORE EXTRACTING OIL.
CLOSE BALL VALVE (4) BEFORE 5.
PRESSURIZATION. Do not attempt
to pressurize Tank (1) with Ball Valve
open.
IF USED OIL DOES NOT 6.
EVACUATE TANK (1) UPON
To Next Page
Loading...