Central Pneumatic CONTRACTOR 92359 - User Maintenance and Safety; Tool Operation and Airflow; Maintenance and Repair Safety

Page 13For technical questions, please call 1-800-444-3353.SKU 92359
drive cylinder of the tool. Make sure
to dry off the Roong Nailer before
use. Any oil lm left after cleanup will
accelerate tar buildup.
7. When nished using the Roong
Nailer, always disconnect the tool
from its compressed air supply.
Attempt to re the Roong Nailer
into a piece of scrap wood to ensure
it is disconnected and is incapable
of ring any nails. Empty the Nail
Canister (82) completely of nails
8. Make sure to store Roong Nailer in
its Carrying Case and in a clean, dry,
safe location out of reach of children.
9. If the tool requires more force to
accomplish the task, verify that the
tool receives sufcient, unobstructed
airow (CFM) and increase the
pressure (PSI) output of the regulator
up to the maximum air pressure
rating of this tool.
CAUTION! TO PREVENT TOOL
AND ACCESSORY FAILURE,
RESULTING IN INJURY:
Do not exceed the tool’s maximum
air pressure rating.
10. Clean external surfaces with clean,
dry cloth. Then store the tool indoors
out of children’s reach.
USER-MAINTENANCE
INSTRUCTIONS
Procedures not specically
explained in this manual
must be performed only by a
qualied technician.
TO PREVENT
SERIOUS INJURY
FROM ACCIDENTAL
OPERATION, BEFORE ANY
MAINTENANCE OR REPAIRS
ARE DONE (including clearing
jams):
• Wear ANSI-approved safety
goggles with side shields.
Other people in the work area
must also wear ANSI-approved
impact safety goggles with side
shields.
• Release the trigger.
• Detach the air supply.
• Attempt to re the Tool into a
piece of scrap wood to ensure
that it is incapable of ring
any fasteners.
• Empty Canister and leave it
open during service.
TO PREVENT SERIOUS
INJURY FROM TOOL
FAILURE: Do not use
damaged equipment. If
abnormal noise, vibration,
or air leaks is detected, have
the problem corrected before
further use.
TO PREVENT EXPLOSION:
Lubricate only with specied
lubricants. Lubricate air inlet
using only pneumatic tool oil.
Lubricate internal mechanism
using only white lithium
grease. Other lubricants may
damage the mechanism and
may be highly ammable,
causing an explosion.