Next 8 registers are for PAN42 sensors. N = Slot No. 0-31
3.
Extended parameters - Array of 32 slots x 4 registers each. N = Slot No. 0-31
Only for Pan42.
Entry index number +1 of
additional Pan42 data in the
Additional parameters
table (next
table).
Range: 1 – 9. For other sensors = 0.
PAN42 errors: (see note below)
1 = EEPROPM read error
2 = EEPROPM write error
3 = Energy counter rollover
4 = Energy counter manual reset
4. Additional parameters – Array of 9 slots x 18 registers each (up to 3 PAN42). n= additional_idx-1 of Slot N (N= Slot No. 0-31)
Active Energy – Phase #X
[Watt-hr]
Phase Consumed Active Energy
Exported active energy –
Phase #X [Watt-hr]
Phase Exported Active Energy
Phase SAG events count in last
minute
Phase SAG events duration (msec)
in last minute
in Ph1: Ph1-Ph3; in Ph2: Ph2-Ph1;
in Ph3: Ph3-Ph2
SWELL condition - Phase
#X
Phase SWELL events count in last
minute
SWELL duration - Phase
#X
Phase SWELL events duration
(msec) in last minute
To Next Page
