Need help?Do you have a question about the Centrica Panoramic Power and is the answer not in the manual?
General| Category | Network Hardware |
|---|---|
| Connectivity | Wireless |
| Power Monitoring | Yes |
| Power Supply | Battery |
| Communication Protocol | Zigbee |
| Measurement Accuracy | ±1% |
Instructions for unboxing the bridge and identifying its components.
Step-by-step guide to connect the RF and cellular antennas to the bridge.
Procedures for physically installing the bridge on surfaces or DIN rails.
How to connect external pulse outputs from meters to the bridge.
Steps to access and navigate the bridge's web-based configuration interface.
How to enter username and password for accessing protected configuration pages.
Guide for setting up the bridge to connect to a Wi-Fi network.
Steps to configure the bridge for cellular (GSM) network connectivity using a SIM card.
Instructions for configuring the bridge's Ethernet connection.
How to configure NTP settings for accurate time synchronization on the bridge.
How to enable and configure the bridge's physical pulse input channels.
Procedures for loading configurations from files and saving current settings.
How to change default server URLs, ports, and reset to factory defaults.
How to change the default username and password for the web interface.
Steps to restore the bridge to its original factory settings.
How to check the current configuration and connection status of the bridge.
Explanation of the bridge's LED indicators and their meanings for operational status.
Methods to test and confirm Wi-Fi, cellular, and server connectivity.
Guide on how to update the bridge to the latest firmware version.
Steps for diagnosing and resolving common connection problems and operational issues.
Steps to extract debug logs for advanced issue investigation.
To Next Page
