9. Reconnect the bridge to the power source.
Note This functionality does not exist in all versions.
Configuring the Bridge for Wired LAN
If you use a wired connection to access the Internet, there are four methods to
allocate an IP address:
1. Automatically obtain the IP address and DNS server.
2. Use a static IP address and DNS server.
3. Automatically obtain an IP address and use static DNS.
4. Use a static IP address and obtain the DNS server.
Prerequisites
If you need a static IP address for the bridge, make sure to have the network
setting information ready before starting the procedure.
For Wi-Fi and ethernet connections, verify that the system administrator has
opened ports 8051/443 for inbound/outbound TCP/IP traffic. In addition, verify
that DHCP & DNS ports are open (67/68, 53) and NTP port are open (123).
How to Proceed
5. In Connection Type, select Connect via LAN.
6. In IP Settings, select whether you want the bridge to:
Automatically obtain an IP address and DNS server.
Use a static IP address and DNS server.
Automatically obtain an IP address and use static DNS.
Use a static IP address and obtain a DNS server.
7. If you select to enter the IP address manually, several fields become
active (IP Address, Subnet Mask, etc.). Fill them in according to your
required network settings.
8. If you select to enter only the DNS servers manually, only the DNS
fields will be active. Fill them in according to your required network
settings.
9. If you select to enter the IP address manually, but obtain the DNS
servers automatically, several fields become active (IP Address,
Subnet Mask, Gateway). Fill them in according to your required
network settings.
10. To save the configuration to the bridge, click Save Settings.
To Next Page
Loading...
