Why my CENTURION SYSTEMS Door Opening System will not operate?
If your CENTURION SYSTEMS Door Opening System isn't operating, first, ensure the mains power is turned on. If the power is on, check for any obstructions preventing the door from moving and remove them.
What to do if CENTURION SYSTEMS Door Opening System operates from drive unit but not from hand transmitter?
If your CENTURION SYSTEMS Door Opening System operates from the drive unit but not the hand transmitter, first try operating the door with an alternative transmitter. If that doesn't work, ensure the receiver antenna wire is straight. Also, check the transmitter battery and replace it if it's flat (12V).
Why does CENTURION SYSTEMS Door Opening System stop on upward cycle?
If your CENTURION SYSTEMS Door Opening System stops on the upward cycle, first disengage the opener and check the door for free movement, as it may be obstructed. If there is no obstruction, door springs may have lost tension, in which case you should call a serviceman to affect repairs.
Why is autoclose not working on my CENTURION SYSTEMS Door Opening System?
If the autoclose feature is not working on your CENTURION SYSTEMS Door Opening System: * Check the P.E. beam for faults or broken wiring and repair if necessary. * Ensure that there are no obstructions in the path of the P.E. beam.
What to do if CENTURION SYSTEMS Door Opening System is locked or motor jammed?
If your CENTURION SYSTEMS Door Opening System is locked or the motor is jammed, first check if the mechanical door lock has been engaged and unlock it. Then, inspect the door for any jams and remove them.
General| Brand | CENTURION SYSTEMS |
|---|---|
| Model | RDO II |
| Category | Door Opening System |
| Language | English |
Installation by qualified persons; door must be balanced and functional.
Follow instructions, use qualified repairs, keep area clear, use correct power.
Monthly checks and testing of the Safety Obstruction Reversing System.
Procedures to test safety force adjustment for open and close directions.
Problems with reverse function, transmitter communication, and safety settings.
To Next Page