- 16 - INSTALLATION MANUAL – RDO
Learning a button to Function Two will enable that button to switch the Courtesy Light on and off.
Operation
Momentarily press the associated transmitter button to either switch the courtesy light on or off. If the light has been
switched on, it will time out as per the maximum current timer of 2 minutes.
Learning procedure
Press the Learn button TWICE to select Function Two Learn, if the operator is still in Learn Mode, the Learn button
need only be pressed once. The LED indicator will flash twice every two seconds to confirm that Function Two Learn
has been selected. Take the remote control or wall pendant that must be learned into the system, press and hold the
desired button for three seconds. The LIGHT and LED will flash three times if the transmitter has been successfully
learned into Function Two and will activate the courtesy light upon being pressed. The system will remain in this learn
mode for 10 seconds after the last remote or wall pendant is learned and automatically exit after this time. The function
can be learned to any button, provided that the button has not yet been learned to another function.
To Next Page