To Next PageTo Next Page
Need help?Do you have a question about the Certikin Genie MB35S and is the answer not in the manual?
General| Model | Genie MB35S |
|---|---|
| Category | Swimming Pool Heater |
| Heat Output | 35 kW |
| Voltage | 230 V |
| Fuel Type | Natural Gas or LPG |
| Phase | Single Phase |
| Inlet/Outlet | 1.5 inch BSP |
Detailed specifications including dimensions, weight, and clearances.
Data on heat input, output, efficiency, and gas rates for different models.
Critical safety warnings regarding fire, explosion, and gas leaks.
Explanation of the heater's control panel elements and their functions.
Explains Pool Demand LED, Pool Pump Pressure, and Overheat indicators.
Details Condensate Blockage and Overheat fault codes and indicators.
Covers water temperature settings, chemistry, cleaning, and winterisation.
Guidelines for siting the heater, including floor support and clearances.
Legal compliance for gas appliance installation by qualified personnel.
Lists British Standard codes applicable to gas appliance installations.
Requirements for gas supply, pipework, and on-site conversion to LPG.
Guidance on flue types, lengths, and installation considerations.
Notes on air supply needs and procedures for outdoor heater placement.
Specifies required clearances and outlines the general installation steps.
Details the Flue Equivalent Lengths (FEL) for various flue kit parts.
Guidance on fitting the horizontal wall terminal and required core drill size.
Diagrams showing heater dimensions and key connection points.
Diagrams showing dimensions for horizontal wall terminals.
Illustrates dimensions for outdoor and vertical roof flue terminals.
Visual examples of flue configurations and a table of kit part codes.
Lists flue kit part codes, their descriptions, and Flue Equivalent Lengths.
Details on plumbing connections, pump requirements, and minimum flow rate.
Instructions on how to check and adjust the water pressure switch.
Step-by-step guide for converting the heater to LPG fuel.
Procedures for connecting gas supply and checking for leaks and combustion.
Methods for connecting and routing the condensate drain pipe.
Safety and wiring requirements for electrical supply and control connections.
Illustrates methods for disposing of condensate via soakaway or stack.
Important information regarding inhibitor, air purging, and initial setup.
Steps for setting up the heater, checking gas rate, and performing leak tests.
How to enter and navigate the user setup mode for configuration.
Instructions for installing the kit to connect multiple heaters.
Describes how the system operates in multi-heater mode and its features.
Steps to install the wall mounting kit for the heater.
Conditions for operation, ignition sequence, and safety controls.
Procedures for accessing User Setup and Service modes for diagnostics.
Comprehensive list of fault codes, display indicators, and troubleshooting actions.
Recommended inspection and maintenance tasks for regular servicing.
Procedures for servicing the burner, electrodes, and various components.
Notes on pipework integrity, seals, and condensate syphon cleaning.
How to measure and adjust gas rate and combustion parameters.
Lists replaceable parts and safety precautions before starting work.
Catalog of available spare parts with manufacturer and supplier part numbers.
Identification of key electrical components on the chassis.
Diagrams showing the location of major heater components.
Fields for logging installer, date, pressure, and user instruction.
Record keeping for routine maintenance, pressure, and combustion checks.
