Cervis TM70 Operation & Installation Manual

TM70Bi.v1.1.doc (10/03) 4
3.- SAFETY INSTRUCTIONS
These instructions must be read carefully in order to install and use
the system properly, to keep it in perfect working condition and to
reduce the risks of misuse.
Do not use this system on machines for the lifting of persons or in
potentially explosive atmospheres.
Any use other than that specified in this manual is dangerous. The
following instructions must be strictly adhered to.
3.1.- WHAT YOU MUST DO
 Strictly adhere to the instructions for installation contained in this manual.
 Make sure that professional and competent personnel carry out the installation.
 Ensure that all site and prevailing safety regulations are fully respected.
 Make sure that this manual is permanently available to the operator and maintenance
personnel.
 Keep the transmitter out of reach of unauthorised personnel.
 Remove the transmission key when the transmitter is not in use.
 At the beginning of each working day, check to make sure that the STOP button and
other safety measures are working.
 When in doubt, press the STOP button.
 Whenever several systems have been installed, make sure the transmitter you are
going to use is the right one. Identify the machine controlled on the label for this
purpose on the transmitter. An audible or visual warning device indicating the machine
is electrically active and the transmitter has control should be installed on the machine.
 Service the equipment periodically.
 When carrying out repairs, only use spare parts supplied by Cervis dealers.
3.2.- WHAT YOU MUST NOT DO
 Never make any changes to the system, which have been studied and approved by
Cervis.
 Never power the equipment other than with the specified power supply.
 Never allow unqualified personnel to operate the equipment.
 After use, never leave the equipment ON. Always use the contact key or the STOP
button to avoid accidental movements.
 Do not use the system when visibility is limited.
 Avoid dropping the transmitter.
 Do not use the system if failure is detected.

Cervis TM70 Specifications

General

Brand	Cervis
Model	TM70
Category	Remote Control
Language	English