Installation
3
Installing the Speakers
Your new Cerwin Vega Mobile series speakers were designed with the flexibility to be installed in multiple locations. However,
to ensure the best performance possible, it is important to isolate the front sound waves of the speaker from its rear sound
waves. This is done by securely mounting the speaker to a flat surface known as a baffle. Make sure to seal the speaker to
ensure there are no air leaks around its frame.
Selecting a Location
If your vehicle has existing factory locations, the easiest method would be to replace them with the exact same size speaker.
In the case where there is not a factory speaker location, there are many places where the speakers will fit in a vehicle, but
they are not always the best locations for good sound. Make sure to take the time to select the best locations possible.
Mounting the speakers so that they are equal distance from your ears will achieve the best results. If you experience any
difficulties, please consult with your local authorized Cerwin-Vega Mobile dealer. They have the tools and know-how to help
Door Mounting (if not using factory locations)
Prior to cutting, remove the panel from the door and check for clearance in the in the intended installation area, making sure
the window will go all the way up and down without any interference. Avoid cutting any structural metal support or braces to
mount the speakers. We HIGHLY recommend that for the BEST sound you put a sound deadening mat on the door “skin”
(as shown below). The more “damped” your car is.... the better it will ultimately sound!!!
SOUND DEADENING
Door Mounting
To Next Page
Loading...
Need help?
General
