8
Troubleshooting
NoSound
Is it one speaker or both speakers? If it is the RIGHT speaker only, check that the XD Speaker
CableissecurelyfastenedbetweentheLEFTand RIGHTspeaker.Inasubwoofersystem,ifboth
speakersdonotproductaudio,butthesubwooferdoes,checkthatthereisanaudioconnection
fromtheoutofthewoofertotheinputofthespeakerpair.Ifthesubwooferisnotworkingand
audiocan be heard from the LEFT andRIGHT speaker, the audio inputconnectionsis incorrect.
Theaudioinputconnectionmust bemadeonthesubwooferfirst.
IfitisbothLEFTandRIGHTspeakers,verify
thepowerswitchisonandthepowercord
is used on an active outlet. The Volume
ring on the LEFT speaker should be
illuminated RED color when the speaker
systemisactivewithpower.
After the power is confirmed, check that
the audio input cables are connected
correctly and the audio source is playing.
Be sure the volume level on the audio
source is not set to MUTE or at minimum
level.BesurethevolumeknobontheLEFT
speaker is not at minimum
level (full
counter‐clockwise). In quiet (low listening
level) situations, adjust the gain stages by
setting the volume to middle or lower and
increase the input level of the audio
source.
BadSound
Verifythatallaudiorelatedconnectionsare
securely attached. For example, make sure
the audio input connectors are clean and
fullyinsertedintothejack.
Check that the wiring is not restricted and
not in close proximity to electrical
interference sources such as power cords,
mobilephonesordimminglight.
Distortedornoisysoundcanresultfromthe
source(computerorpo rtablemediaplayer).
Try to listen to the source using a set of
headphones and adjusting the volume to
different levels. If the audio is bad through
the headphones, than the source is the
orttubesarenotobstructed.
The subwoofer features numerous controls to tame low frequ ency sounds. First, be sure the
crossover setting is in the correct position for the speakers being used. Smaller size speakers
requirethecrossovertobesetat ahigherfrequency.Largersizespeakersrequirethecrossover
to be set at a lower
frequency. The BYPASS setting is recommended for use with LFE or
dedicated subwoofer outputs. The subwoofer volume should be set when playing your most
intensebassmusic
To Next Page
Loading...
