CES SDI-50 - 8 Sdi-50 Programming Log

Model SDI-50 Manual, Repeater Controller
SDI-50 PROGRAMMING LOG
PROGRAM FACTORY
CODE DESCRIPTION SETTING CHANGED TO
*1
TIMERS TIME
0 Sample Rate (Simplex) 1 sec. ___________
1 Sample Window (Simplex) 60 ms. ___________
2 Repeater Time Out Timer (Dúplex) 7 min. ___________
3 Repeater Hang Time (Dúplex) 2 ms. ___________
4 Call Limit Timer 3 min. ___________
5 Mobile Activity Timer 20 sec. ___________
6 I.D. Interval Timer 10 min. ___________
*5
SOFTWARE SWITCHES SETTING
00 Toll restrict on number 7 off ___________
01 Toll restrict on number 6 off ___________
02 Toll restrict on number 5 off ___________
03 Toll restrict on number 4 off ___________
04 Toll restrict on number 3 off ___________
05 Toll restrict on number 2 off ___________
06 Toll restrict on number 1 on ___________
07 Toll restrict on number O on ___________
10 Toll restrict on number 8 off ___________
11 Toll restrict on number 9 off ___________
12 Selectivo Signaling on ___________
13 "*" Call Limit Reset on ___________
14 Simplex enable (note 1) (simplex) off ___________
15 Toll restrict on 1st digit (note 2) on ___________
16 Toll restrict on 2nd digit on ___________
17 Pulse dialing off ___________
20 Toll Restriction Override on ___________
21 Single digit "*" connect off ___________
22 single digit "#" disconnect on ___________
23 2X Sample Rate (note 2) (Simplex) off ___________
24 4X Sample Rate (Simplex) off ___________
23 Repeat enable (note 1) (Duplex) on ___________
24 Courtesy Beep Enable (Duplex) off ___________
25 Answer on 1,2,4 or 8 rings (note 2) on ___________
26 Used Together With #25. off ___________
27 Interconnect enable on ___________
30 Mobile Signalling Wait Time (note 2) on ___________
31 Used Together With Code #30 off ___________
32 Ringout enable on ___________
33 Toll restrict on ___________
34 Auto I.D. on ___________
35 Auto answer off ___________
36 Half/Full Dúplex Enable on ___________
37 Repeat Enable on ___________
Page #40