CEVIK PRO PRO 25 SILENC - Storage; Problem Solving

27
STORAGE.
If you need to store the equipment for a long time, then:
1. Turn the pressure switch to the off position.
2. Disconnect the equipment from the electrical contact.
3. Empty the tank through the safety valve.
4. Clean the compressor to remove impurities or dust.
5. Cover the compressor, so that dust does not enter.
6. Place the compressor in a dry place. Do not place objects on top.
PROBLEMS SOLVING.
Item
Description
Possible cause
Solution
1
Power switch does
not work.
Loss of contact in some
electrical connection.
Check all electrical
connections.
Pressure switch damaged.
Contact a Technical
Service.
2
It starts but it goes
very slow.
The supply voltage is less
than 220V.
Do not use a power
cord extension. Look for
an alternative energy
source.
3
Loss of air pressure
in the tank or very
slow load.
The tank trap is not closed.
Close the trap.
Safety valve is open.
Check safety valve, if
necessary replace it.
Dirty or clogged air filter.
Clean or replace it.
4
Excessive heating.
Fans do not work. Replace
fans.
Replace fans.
Clogged fans.
Remove obstruction.
5
Any other cause.
Unknown.
Contact one of our
technical services.