OPERATION OF YOUR ATV
90
Vehicle turning dynamics
To achieve maximum traction while operating in 2WD or 4WD, the two rear wheels perform as one axle
and turn together at the same speed. Furthermore, when operating in 4WD-LOCK mode, the front wheels
will also turn together at the same speed. Therefore, unless the wheel on the inside of the turn is allowed
to slip or lose some traction, the Vehicle will resist turning. The special turning technique described in this
manual must be used to allow the Vehicle to make turns quickly and easily. It is essential that this skill be
learned first at low speed.
WARNING
Always follow proper procedures for turning as described in this Owner s Manual. Practice turning at low
speeds before attempting to turn at faster speeds. Do not turn at speeds too fast for your skills or the
conditions. Operate at a slow speed and allow extra time and distance for maneuvers when in 4WD -
LOCK ( DIFF. LOCK ).
As you approach a curve, slow down and begin to turn the handlebars in the desired direction. As you do
so, put your weight on the footboard to the outside of the turn (opposite your desired direction) and lean
your upper body into the turn. Use the throttle to maintain an even speed through the turn. This maneuver
will let the wheel on the inside of the turn slip slightly, allowing the Vehicle to make the turn properly.
Turning on curves
As you approach a curve, slow down and begin to turn the handlebars in the desired direction. As you do
so, put your weight on the foot board to the outside of the turn (opposite the desired direction) and lean
your upper body into the turn. Use the throttle to maintain an even speed through the turn. This maneuver
will let the wheel on the inside of the turn slip slightly, allowing the Vehicle to maneuver the turn properly.
To Next Page
Loading...
Need help?
General
