At any time press OK or wait 10 seconds will return to Normal mode.
Note: Control temperature can only be set in the range from 10
0
C to 35
0
C in step of 0.5
0
C (45
0
F to
95
0
F, 1
0
F step).
In Heat mode, the Econ set-temp cannot be set higher then that of Comfort. In Cool mode,
condition vice versa.
5.4. Program override
Program override is function in Normal mode in which the program set point is temporary
changed. There are 3 types of program override. Program override indicator flashing when set.
5.4.1. Temporary program override
1. Press __ button to toggle between normal set-temperature and setback function in heat mode,
press __ button to toggle between normal set-temperature and off mode in cool mode.
2. Press and release COMF/ECON button (for less than 1.5 seconds) to toggle between
comfortable and economic set temperature. Program override icon will be displayed and
the temporary set temperature mode will be displayed accordingly.
3. Continue to hold the key for 1.5 seconds to change the set-temp to Defrost.
4. The Override indicator is flashing and Temporary program override is set.
Note: For cool mode, setback and defrost and not available, which will shows “-- -“ or “--“ at set-
temp.
15
To Next Page
Loading...
