Chacon 54311 - 5. Programming and Scheduling; Setting Time and Day; Creating Program Schedules

5. Programming
5.1. Set the time & day
1. In normal mode, press and hold SET button for 4 seconds, until LCD display “C” (Clock).
2. Release SET to enters clock setting mode, the clock freezes and the center dot does not flash.
3. Hour is flashing, press “ ” or “ ” button to adjust
4. Press SET to change to minute. Press “
” or “ ” button to adjust
5. Press SET to change to day. Press “ ” or “ ” button to adjust
6. Press SET again to save and exit or it will return to the front screen after 15 seconds.
At any time press OK or wait 15 seconds will return to Normal mode.
5.2. Setting program
There are altogether 9 programs.
1. In normal mode, press and hold SET button for 7 seconds, until LCD display “P” (Program).
2. Release SET to enters Program setting mode.
3. Press SET to select the day to program.
If the Program day option is set to “5 – 2”, then the day selectable are “MON – FRI”, “SAT –
SUN” and “MON – SUN”. The program data display changes accordingly.
4. Press PROG to change the program. Program is selectable form 1 to 9.
11