CHAINTECH 6AJA4 - Power on by PCI Card; Power on by Modem;Lan; Power on by Alarm

35
Award BIOS Setup Program
H. Power On By PCI Card
Enable this selection to use the Power on by PCI card function.
I. Power On By Modem/LAN
When enabled, a modem/LAN that receives a signal will wake up the system
from soft off and green mode. You should connect the modem to the COM
port and turn on the resume event in green mode.
J. Power On By Alarm
When enabled, this setting allows the system to turn back on at a designated
time of the month. User must designate date of month and time of day. This
function is only available when using an ATX power supply and the Software
Power-Off function to turn off the computer. See the Software Power-Off feature
in Section 2-4 of this manual for instructions.