EasyManua.ls Logo

Challenge GY6000 - Electrical Safety

Challenge GY6000
20 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Important - Please read these instructions fully before starting assembly
11
Customer Helpline 0343 515 1906
Electrical safety
CAUTION! The following states how to avoid accidents
and injuries due to electric shock:
Damaged cables, coupling and plugs or connecting
leads not corresponding to specications, must not be
employed. Remove the plug immediately from the plug
socket in case of damage to the mains cable.
Do not touch the mains power supply cable under any
circumstances until you have pulled the plug out of the
mains socket.
If the power cable for this equipment is damaged, it must
be replaced by the manufacturer, a customer service
agent of the same or a similarly qualied person in order
to prevent hazards.
Do not use the appliance if the on/off switch does not
work properly. Always have a damaged switch repaired
by our a qualied technician.
Only use extension cables that have been approved for
outdoor use and are resistant to splash water. The core
diameter for extension cables measuring up to 25 m
must be at least 1.5 mm², and 2.5 mm² for cables longer
than 25m. Always roll the whole cable off the reel before
use. Check the cable for damage.
Do not unplug the shredder pulling on the cable, only pull
the plug itself. Keep the cable away from heat, oil and
sharp edges.
General Safety (continued)
Safety Information