15
Customer Helpline 0343 515 1906
Start- up
ON/OFF Operation
Emptying the Collection Box
Overload Protection
Restart Prevention
Operation
Check that the mains voltage matches the rating on the name plate.
Hook the collection box into right place.
Press the switch marked “1” to start and marked “0” to stop the motor.
Avoid lling the collection bag too much. Mind that the bag will ll unevenly under the discharge duct!
• Turn off the unit.
• Remove and empty the collection bag
4
.
Press the “circuit breaker” button if the machine does not work, ensure you have connected to the
power supply.
When the motor has been running for a few seconds you can commence shredding.
The circuit breaker will be activated in the following circumstances:
a. A build up of shredded material around the cutting disc.
b. If the material bring shredded is greater then the motor capacity.
c. Where there is too much resistance against the cutting blade.
When the circuit breaker has been activated switch-off the shredder and disconnect the power supply.
a. Unscrew the reamer knob at the base of the turret and open top section
b. Remove the debris or obstruction from the cutting area
c. Return the top section and tighten the reamer knob.
d. Leave motor a few minutes to cool down
e. Reconnect to the power supply and press the circuit breaker button.
f. When ready to start shredding press the “1” switch.
The unit will not automatically restart when the power returns after a power cut. To restart the unit, turn
the on/off switch to “off“ then back to “on“.
To Next Page
Loading...