18
Customer Helpline 0343 515 1906
Reversing, Sharpening, Replacing the Blade
Maintenance and Cleaning
Usage
Maintenance
When both cutting edges of the blade have become worn they must be replaced as a pair. The blades
can be re-sharpened, but this must be done by an experienced person using an oil stone.
We do not recommend this be done as the weight of each blade is critical to maintain the balance of
the cutting disc.
Any imbalance could cause damage to the machine and possible injury to the operator.
Warning: During maintenance and cleaning ensure the machine is disconnected from the mains.
• When the appliance is stopped for servicing, inspection, or storage, or to change an accessory,
switch off and pull the plug from the mains supply before making any inspections, adjustments,
etc.13
• If an extension cord is used it shall not be of lighter grade than the supply cord already tted to the
appliance.
• Check the supply and any extension cord regularly for damage or signs of ageing. Do not use the
appliance, if the cords are damaged.
• When servicing the cutting means be aware that, even though the motor will not start due to the
interlock feature of the guard, the cutting means can still be moved if the motor is turned by hand.
• Never attempt to override the interlock feature of the guarding.
• Remove deposited matter from the machine using a brush.
• Always clean the machine after use. Clean the plastic body and plastic parts using soap and a
moist cloth. Do not use aggressive agents or solvents for cleaning.
• Never clean the shredder with a jet of water or by rinsing. Make sure that no water is allowed to
enter into the shredder.Use only the recommende.
To Next Page
Loading...