AP11LCD / AP11LED Manager Guide
AP11LED/LCD-Manager- Rev 02
LED Keypad
How to Set the System
Full Set
When you leave your premises you will need to set the intruder alarm system.
Before setting the system you should ensure that the premises have been completely vacated and
that all doors and windows are closed. Ensure that pets do not have access to the protected areas
as they can cause a false alarm.
Part Set
If your installer has programmed your system for PART SET operation you will be able to set
some zones of the system while others remain unset. Part set operation is often used at night time,
and it will permit you to free walk around the bedrooms while the living are and outside doors
are protected. Your system may have 2 part-set programs called Part 1 and Part 2.
Before Part-setting the system you should ensure that all doors and windows are closed. Ensure
that pets do not have access to the protected areas. Your installer may have instructed you to use
a different keypad to the one normally used to set the system.
Note:
·
There will be no exit beeps if Silent Exit mode was programmed.
·
You should wait until you hear that the exit beep has stopped before assuming that the
system has set.
LED Remote Keypad :
·
System is in Day mode
·
Enter User code/Manager code
Day LED will flash 5 second, then you can
select arm mode.
·
Press key to select Full arm mode,
Or press key to select Part 1 arm mode,
Or press key to select Part 2 arm mode.
Or press key to exit.
·
··
·
If the system has faults, you can see the fault
from the LED’s and the fault tone will be generated.
These faults will need to be cleared before the system
can be set
·
Press key quick set the system.(Optional)
10
10
10
Count down beep
E
S
T
R ES TE
E
S
T
10
Exit error beep
O IMT
To Next Page
Loading...
Need help?
General
