)NSTALLATION
$ETERMINE THE (EADER "RACKET ,OCATION
4O PREVENT POSSIBLE 3%2)/53 ).*529 OR $%!4(
z (EADER BRACKET -534 BE 2)')$,9 FASTENED TO STRUCTURAL SUPPORT ON HEADER WALL OR CEILING
OTHERWISE GARAGE DOOR MIGHT ./4 REVERSE WHEN REQUIRED $/ ./4 INSTALL HEADER BRACKET
OVER DRYWALL
z #ONCRETE ANCHORS -534 BE USED IF MOUNTING HEADER BRACKET OR X INTO MASONRY
z .%6%2 TRY TO LOOSEN MOVE OR ADJUST GARAGE DOOR SPRINGS CABLES PULLEYS BRACKETS OR
THEIR HARDWARE !,, OF WHICH ARE UNDER %842%-% TENSION
z !,7!93 CALL A TRAINED DOOR SYSTEMS TECHNICIAN IF GARAGE DOOR BINDS STICKS OR IS OUT OF
BALANCE !N UNBALANCED GARAGE DOOR MIGHT ./4 REVERSE WHEN REQUIRED
z $/ ./4 ENABLE THE 4IMERTO#LOSE FUNCTIONALITY IF OPERATING EITHER ONEPIECE OR SWINGING
GARAGE DOORS 4O BE ENABLED /.,9 WHEN OPERATING A SECTIONAL DOOR
#LOSE THE DOOR AND MARK THE INSIDE VERTICAL CENTERLINE OF THE GARAGE DOOR
%XTEND THE LINE ONTO THE HEADER WALL ABOVE THE DOOR 9OU CAN FASTEN THE HEADER BRACKET WITHIN FEET
M OF THE LEFT OR RIGHT OF THE DOOR CENTER ONLY IF A TORSION SPRING OR CENTER BEARING PLATE IS IN THE
WAY OR YOU CAN ATTACH IT TO THE CEILING WHEN CLEARANCE IS MINIMAL )T MAY BE MOUNTED ON THE WALL
UPSIDE DOWN IF NECESSARY TO GAIN APPROXIMATELY Ñ CM )F YOU NEED TO INSTALL THE HEADER BRACKET
ON A X ON WALL OR CEILING USE LAG SCREWS NOT PROVIDED TO SECURELY FASTEN THE X TO STRUCTURAL
SUPPORTS
/PEN YOUR DOOR TO THE HIGHEST POINT OF TRAVEL AS SHOWN $RAW AN INTERSECTING HORIZONTAL LINE ON THE
HEADER WALL Ñ CM ABOVE THE HIGH POINT 4HIS HEIGHT WILL PROVIDE TRAVEL CLEARANCE FOR THE TOP EDGE
OF THE DOOR
./4% )F THE TOTAL NUMBER OF INCHES EXCEEDS THE HEIGHT AVAILABLE IN YOUR GARAGE USE THE MAXIMUM
HEIGHT POSSIBLE OR REFER TO PAGE FOR CEILING INSTALLATION
Header Wall
Unfinished
Ceiling
Vertical Centerline
of Garage Door
2x4
2x4
Structural
Supports
Level
(Optional)
OPTIONAL
CEILING
MOUNT FOR
HEADER
BRACKET
Sectional door with curved track
Header Wall
Track
2" (5 cm)
Highest Point
of Travel
Door
To Next Page
