Programming
Number
Factory
Setting
Description of Task Programming Procedure
***
12 # Enable/Disable True Anti-Passback (0 = disable;
1 = enable) # Enable/Disable Timed Anti-Passback (0
= disable; 1 = enable) #
15 # (0 – 1; 0 = one long ring, 1 = double ring) #
14 # (1 – 9) #
Disabled
11
Enable/Disable Unlock Time Zone
11 # (0 = disable; 1 = enable) #
Enable/Disable Real-Time Monitoring
Set Maximum Number of Rings
Allowed Before Aborting Attempt
Set “Strikes” and “Out”
Enable/Disable Direct Commands
24
24 # (0 = disable; 1 = enable) #
Enabled
Enable/Disable Access Granted Beeps
23
23 # (0 = disable; 1 = enable) #
Disabled
Enable/Disable Voice Mail
22
22 # (0 = disable; 1 = enable) #
Enabled
21
21 # (0 = disable; 1 enable) #
Enable/Disable the Telco Mode
Enabled
Enabled
10
Enable/Disable Do Not Disturb Schedule
10 # (directory code) # (0 = disable; 1 = enable) #
Disabled
20
20 # (0 = disable; 1 = enable) #
Set Microphone Volume
5
19
19 # (0 = mute; 1-10, 1 is low and 10 is high) #
Set Speaker Volume
5
18
18 # (0 = mute; 1-10, 1 is low and 10 is high) #
3 Errors
17
17 # (max errors, 0-5) #
Number of Rings Before Unit Answers
5 Rings
5 Rings
0 = One
Long Ring
16
Set Standard Single Ring or Double
Ring Response
15
14
16 # (0 – 15) #
Each unit in chain must have same setting
Set Anti-Passback Time
3 Minutes
9
Enable/Disable Call Waiting
9 # (0 = disable; 1 = enable) #
Enabled
Set Entry Code Length
7
7 # (3-9) #
4 Digits
Set Directory Code Length
6
6 # (1 or 2) #
2 Digits
Set Visitor Talk Time
5
5 # (15 – 250 seconds) #
60 Seconds
Enable/Disable Daylight Savings Time
4
4 # (0 = disable; 1 = enable) #
Enabled
Set the Clock
3
3 # yymmdd # (day of the week) # hhmm #
Set Unit ID Number and No. in Chain
2
2 # (unit ID number, 1-7) # (Number of Units in Chain, 1-7) #
Unit ID 1, Chain No. 1
Change or Verify the Unit's Password
1
1 # (1 to change; 2 to verify) # (six-digit code) #
000000
Exiting Programming Mode
Entering Programming Mode
0
0 #
***
(6 Digit Password)
13
Enable/Disable Anti-Passback
Disabled
12
13 # (1-60 minutes) #
The Pound Key (#) must be used as Data Field Separator and to Save Data at the end of the sequence.
Time must be entered using a 24-hour format
(8AM=0800, 3PM=1500 etc.
)
2 Short Beeps:
Programming input is valid.
1 Long Beep:
Input is not valid.
If you make an error during an entry, press the asterisk key (
*
) to begin again.
Important:
Guide for Programming the EL25
Optional Steps Indicated with a Background, all other steps are Required
To Next Page
Loading...
