Chamberlain HC250 User Manual

D
F
GB
NL
Anleitung – Drehtorantrieb Modell HC250
Instructions – Portail à battants modéle HC250
Instructions – Wing gate opener model HC250
Instrukties – Draaihekopener model HC250
™
Für Service: (06838) 907-100
Pour Service: .03.87.98.15.93
For Service: 0800 317847
Voor Service: 020 6847978
F
NL
D
GB
B
B
B
B
Declaration of Conformity
Automatic Gate Opener ...........................................................................Model No.HC250
is in conformity to the
applicable sections of Standards ....................................................EN55014, EN61000-3,
EN60529, ETS 300 683,
EN60555, & EN60335-1
EN60034
per the provisions & all amendments
of the EU Directives .....................................................................73/23/EEC, 89/336/EEC
Declaration of Incorporation
Automatic Gate Opener Model HC250, when installed and maintained according to all
the Manufacturer’s instructions in combination with a Garage Door, which has also
been installed and maintained according to all the Manufacturer’s instructions, meet
the provisions of EU Directive 89/392/EEC and all amendments.
I, the undersigned, hereby declare that the equipment
specified above and any accessory listed in the manual
conforms to the above Directives and Standards.
Chamberlain GmbH
D-66793 Saarwellingen
May, 2000
Colin B. Willmott
Chefingenieur

Chamberlain HC250 Specifications

General

Max Gate Weight	2500 lbs
Max Gate Length	50 ft
Type	Sliding Gate Opener
Power Source	AC Power
Motor Type	AC Motor
Control Type	Remote Control
Safety Features	Obstruction Detection
Control Options	Remote Control, Keypad

Summary

1.2 TECHNICAL FEATURES

1.3 HOW TO OPERATE THE DEVICE

Step-by-step guide on how to operate the automated gate system.

1.4 SAFETY ADVISES

Provides critical safety recommendations for the gate automation system.

1.5 FOR HIGHER SAFETY

Details additional measures to enhance the overall safety of the gate system.

1.6 EMERGENCY CONTROL

Explains manual gate operation during system failures.

1.7 COMPLIANCE TO NORMS

Lists standards and directives the equipment adheres to.

2.0 ACTUATORS ASSEMBLY TO PLATE

2.1 FRONT SUPPORT ASSEMBLY

Details the process for installing the front support assembly for the actuator.

2.2 SECOND ACTUATOR ASSEMBLY

Explains how to install the second actuator on the other gate wing.

3.0 WIRING

3.1 STANDARD ELECTRONIC CONNECTIONS

Covers standard electrical connections for system components.

3.2 SPECIAL CONNECTIONS

Details specific or non-standard electrical connection requirements.

3.3 SETTINGS

Explains how to configure various settings for the gate automation.

3.4 SPECIAL ELECTRIC CONNECTIONS: PHOTOCELLS

Describes wiring and setup for photocell safety devices.

3.5 EMERGENCY BATTERY

3.6 KEYSWITCH ASSEMBLY

Instructions for installing and using the optional keyswitch.

3.7 FLASHING LAMP

Details installation and function of the flashing warning lamp.

3.8 TRANSMITTER ENCODING

Explains how to encode and use the remote control transmitter.

4.0 CONTROL LIST

4.1 HELP... TROUBLE SHOOTING

Provides solutions for common problems encountered with the system.

4.2 SPARE PARTS

Lists available spare parts for maintenance and repair.

4.3 ACCESSORIES

Lists optional accessories that can be added to the system.

5.0 WARRANTY