33
Maintenance
Maintenance Schedule
EVERY MONTH
• Manually operate door. If it is unbalanced or binding, call a trained door systems technician.
• Check to be sure door opens and closes fully. Adjust if necessary, see page 26.
• Test the safety reversal system. Adjust if necessary, see page 28.
EVERY YEAR
• Oil door rollers, bearings and hinges. The garage door opener does not require additional
lubrication. Do not grease the door tracks.
The Remote Control Battery
To prevent possible SERIOUS INJURY or DEATH:
l NEVER allow small children near batteries.
l If battery is swallowed, immediately notify doctor.
To reduce risk of fire, explosion or chemical burn:
l Replace ONLY with 3V CR2032 coin batteries.
l DO NOT recharge, disassemble, heat above 212°F (100°C) or incinerate.
The 3V CR2032 lithium battery should produce power for up to 3
years. If the battery is low, the remote control’s LED will not flash
when the button is pressed.
To replace battery, pry open the case first in the middle (1), then at
each side (2 and 3) with the visor clip. Replace the batteries with
only 3V CR2032 coin cell batteries. Insert battery positive side up.
Dispose of old batteries properly.
NOTICE:This device complies with Part 15 of the FCC rulesand IndustryCanada (IC)licence-exempt RSSstandard(s). Operation is
subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that maycause undesired operation.
Anychangesormodificationsnot expresslyapproved by the partyresponsible forcompliance could void the user'sauthority to operate
the equipment.
ThisClassBdigitalapparatuscomplieswith Canadian ICES-003.
Repair Parts
Description Part No.
1 Logic board 047DCT
2 Light lens 041D0166
3 Hardware bag 041A8068
4 Door arm kit: straight door arm, curved door arm, hardware bag 041A8094
5 Door control 041A7367-3
To Next Page
Loading...
Need help?
General
