Chamberlain KLIK2U - Chamberlain Keypad Programming; Type 1 Programming Guide

3
TYPE 1
Chamberlain, Sears Craftsman, LiftMaster,
Master Mechanic and Do It garage door
openers or receivers with: 3 position
DIP switches.
If opener does not function, repeat programming.
Select and write a 4-digit PIN:
__ __ __ __
Determine your opener ID using the list below.
The first DIP switch must be set to the “-” position on your remote and
opener. Record your DIP switch sequence for remaining DIP switches. If
the DIP switch is in the “+” position place a 1, “0” position place a 2, “-”
position place a 3 in the corresponding box in the chart below:
NOTE: Leave any unused switch locations blank.
Enter PIN from step 1, press #.
Enter ID from step 2, press #.
Enter DIP switch sequence from step
3 and press # key.
To test and use, wait until
lights turn off, enter your PIN
and press the 0 key.
1
Programming
2
3
5
6
7
8
DIP Switch
Sequence
123 456 7 8 9
+
0
- 3
Press and hold the * and # buttons until keypad
stops flashing.
4
Opener
Remote Control
ID DIP Switch Type
11 9 DIP switch garage door openers (U.S.)
12 9 DIP switch garage door openers (Canada)
15 8 DIP switch garage door openers
19 7 DIP switch garage door openers