8
Programming to an External Receiver with a LEARN Button
EXTERNAL RECEIVERS (continued)
1
Press the program button on the remote control until
the LED turns on.
2
Press and release the LEARN button* on the external
receiver.
3
Press and release the remote control button, the LED will
flash. When the LED stops flashing, continue to press
and release the button until your product responds by
clicking, blinking, or activating.
4
Press the program button on the remote control to save.
5
Test the remote control by pressing the button. If the product does not activate, repeat the programming steps or follow the
alternative programming option.
Learn Button*
If using the Universal Remote Control with residential door openers, the remote control must be used only with door
openers manufactured after 1993 that utilize photoelectric sensors. The photoelectric sensors are always located on or
near the bottom of the door track.
The external receiver is typically located on the product or mounted near the product.
The images throughout this manual are for reference only and your product may look different.
* Depending on your product, the SMART/LEARN button may have a different
name (use the button for programming remote controls).
STOP
Program Button
Program Button
LED
To Next Page
Loading...
Need help?
General
