PROGRAM TO GARAGE DOOR OPENERS
WITH A YELLOW LEARN BUTTON
If your remote was previously programmed to
another type of opener, follow the programming
instructions on the next page to reprogram to a
yellow LEARN button.
1. Start with the garage door closed.
2. Press and immediately release the yellow
LEARN button. The Learn LED glows steady
for 30 seconds. Within 30 seconds...
3. Press and hold the button on the remote
control you wish to use.
4. Release the button when the garage door
opener lights blink or two clicks are heard.
5. Test by pressing the button you just
programmed. The opener activates.
To program the remote to Chamberlain accessories,
refer to the manual provided with the accessory.
To Next Page
Loading...
Need help?
General
