1
2
1
3
4
L
O
C
K
L
I
G
H
T
2
L
O
C
K
L
I
G
H
T
3
L
O
C
K
L
I
G
HT
26
N
OTE: Your new keyless entry must be
programmed before it will operate your
garage door opener.
Program the keyless entry system
Using the orange “LEARN” button:
1.Press and release the orange “learn” button (1)
on opener. The learn indicator light will glow
steadily for 30 seconds.
2.Within 30 seconds, enter a four digit personal
identification number (PIN) of your choice on
the keypad (2), then press and hold the
ENTER button.
3.Release the button when the opener light
flashes (3). It has learned the code. If the light
bulb is not installed, one click will be heard.
.
NOTE: This method requires two people if the
keyless entry is already mounted outside the
garage.
Using the multi-function door control to
program:
1.Enter a four digit personal identification
number (PIN) of your choice on the keypad,
then press and hold ENTER.
2.While holding the ENTER button, press and
hold the LIGHT button on the multi-function
door control.
3.Continue holding the ENTER and LIGHT
buttons while you press the push bar on the
multi-function door control (all three buttons
are held).
4.Release buttons when the opener light flashes.
It has learned the code. If the light bulb is not
installed, one click will be heard.
Wireless fingerprint access system C379
(optional accessory)
Full instructions are available with this accessory.
Once you have enrolled your user(s) into the C379
you can program the unit into your opener.
Using the orange “LEARN” button:
1.Press and release the orange “learn” button on
opener. The learn indicator light will glow steadily for
30 seconds.
2.Within 30 seconds slide the cover of the C379 up
as illustrated (A). Swipe your finger on the reader
head at a steady speed (B) until the yellow LED
turns on (C).
3.When the opener light flashes it has learned the
code. If the light bulb is not installed, one click will
be heard, ensure there are no obstructions in the
path of the door, then press the send button (D) to
test the door.
Activate the opener only when door is in full view, free of obstruction and properly adjusted. No one
s
hould enter or leave garage while door is in motion. Do not allow children to operate push button(s)
or remote(s). Do not allow children to play near the door.
Programming C379 wireless fingerprint
KEYLESS DEVICE PROGRAMMING (OPTIONAL ACCESSORIES)
12
ENROLL
FAIL
R
ETRY
S
END
PASS
R
EADY
ENROLL
A
E
NROLL
FAIL
RETRY
SEND
PASS
READY
ENROLL
C
B
D
Slide the cover plate
up (A)
Swipe finger at a
steady speed (B)
Yellow LED will indicate
successful swipe (C)
Courtesy light will
flash once.
Test reader by pressing
the send button (D)
To Next Page
Loading...
