1
SERVICE DEPARTMENT: (724) 746-1100
Contents
1.0 INSTALLATION ....................................................... 2
2.0 OPERATION ........................................................... 3
3.0 MAINTENANCE ..................................................... 4
TROUBLESHOOTING GUIDE ........................................... 6
SPECIFICATIONS ......................................................... 7-8
ELECTRICAL SCHEMATICS .............................................. 9
DIMENSIONS AND WEIGHTS................................... 10-12
PARTS LIST ............................................................. 13-14
WARRANTY ................................................................. 16
GENERAL SAFETY INFORMATION
1. Pressurized devices
This equipment is a pressure containing device.
• Do not exceed maximum operating pressure as
shown on equipment serial number tag.
• Make certain equipment is depressurized before
servicing.
2. Electrical
This equipment requires electricity to operate.
• Install equipment in compliance with national and
local electrical codes.
• Standard equipment is supplied with NEMA 1
electrical enclosures and is not intended for
installation in hazardous environments.
• Disconnect power supply to equipment when per-
forming any electrical service work.
3. Breathing air
• Air treated by this equipment may not be suitable
for breathing without further purification. Refer to
OSHA standard 1910.134 for the requirements for
breathing quality air.
7610.724.25B 10/01
CA18-2-635
CRH SERIES HIGH INLET TEMPERATURE
REFRIGERATED DRYERS
MODELS: CRH20, CRH25, CRH35, CRH50,
CRH75, CRH100, AND CRH125
INSTRUCTION MANUAL
To Next Page
Need help?
General
