To Next PageTo Next PageWhat to do if my Champion DH6000T-VHR will not drain?
If your Champion Dishwasher isn't draining, the issue might be: * A dirty drain screen. Clean the screen. * A defective drain valve. Contact Service Agent, open drain valve manually to drain. * A clogged building drain. Contact Building Maintenance.
How to troubleshoot a Champion DH6000T-VHR Dishwasher that will not run and the HMI is unresponsive?
If your Champion Dishwasher won't run and the HMI is unresponsive, consider these potential causes: * The hood is not completely closed or the door switch is faulty. Ensure the hood is completely closed. * The power is off or an overload has tripped. Check the breaker on the panel. * A cycle has not been selected. Select a 1, 2, 4, or 6 min cycle.
Why are the wash results poor with my Champion Dishwasher?
Poor wash results from your Champion Dishwasher may occur due to several reasons: * Wares incorrectly loaded in the dish rack. Reposition wares or reduce the amount of wares. * Clogged screens. Clean the screens. * Clogged spray arms. Clean the spray arms. * Chemical injectors not feeding. Check chemical supplies. * Detergent dispenser leaking. Repair the detergent pump hose. * Water temperature below 55°F for VHR. Increase water temperature to 75°F.
What to do if chemicals won’t feed into my Champion DH6000T-VHR Dishwasher?
If chemicals aren't feeding into your Champion Dishwasher, it could be due to: * Low chemical supply. Refill the chemical container. * Clogged pick-up tube. Rinse the tube with warm water. * Damaged supply tubing. Replace the tubing. * Kinked supply tubing. Straighten the tubing. * Detergent Pump Error because squeeze tube is worn. Replace the squeeze tube.
Why is there low or no water in my Champion Dishwasher?
If you're experiencing low or no water in your Champion Dishwasher, check the following: * Main water supply is off: Open the supply valve. * PRV setting incorrect: Set to 20-22 PSI flowing. * Line strainer clogged: Contact Service Agent. * Valve of float defective: Contact Service Agent.
Why is excessive steam escaping the Heat Recovery System of my Champion DH6000T-VHR?
Excessive steam escaping from the Heat Recovery System of your Champion Dishwasher might be due to: * Incoming cold water temperature above 75°F. Check the incoming water temperature. * Incoming water pressure below 45 PSI flowing pressure at the dishwasher. Check the incoming water pressure. * Recovery coil or fan defective. Check machine level. * Not mentioned: Contact Service Agent.
General| Brand | Champion |
|---|---|
| Model | DH6000T-VHR |
| Category | Dishwasher |
| Language | English |
