What to do if my Champion Dishwasher will not drain?
If your Champion Dishwasher isn't draining, start by cleaning the drain screen. If the problem persists, the drain valve may be defective (contact a Service Agent) or the building drain may be clogged (contact Building Maintenance).
What to do if my Champion Genesis DH5000T Dishwasher has low or no water?
If your Champion Dishwasher has low or no water, start by checking if the main water supply is off and open the supply valve. Also, ensure the PRV is set to 20-22 PSI flowing. If these steps don't resolve the issue, the line strainer may be clogged or the solenoid valve may be defective, in which case you should contact a Service Agent.
Why does my Champion Genesis DH5000T Dishwasher have poor wash results?
Poor wash results from your Champion Dishwasher can occur due to several reasons. Check if wares are incorrectly loaded in the dishrack, and reposition them or reduce the amount of wares. Clogged screens or spray arms can also cause this issue, so clean them thoroughly. Other potential causes include chemical injectors not feeding properly (contact your Chemical Supplier), a defective thermostat (contact a Service Agent), a defective detergent dispenser (contact your Chemical Supplier), or low water temperature (contact a Service Agent).
How to fix a Champion Dishwasher that will not run?
If your Champion Dishwasher will not run, make sure the hood is completely closed. Check the breaker on the panel to ensure the main power is on. Also, verify that the dishwasher is turned ON.
Why aren't chemicals feeding into my Champion Dishwasher?
If chemicals aren’t feeding into your Champion Dishwasher, first check if the chemical supply is low and refill the chemical container. A clogged pick-up tube might also be the problem (contact your Chemical Supplier). Additionally, inspect the supply tubing for damage or kinks, and straighten the tubing if necessary. If the supply tubing is damaged, contact your Chemical Supplier.
What to do if my Champion Genesis DH5000T stays in wash cycle too long?
The Champion Dishwasher might stay in the wash cycle longer than expected because the Rinse Sentry extends the wash mode to allow the final rinse water booster temperature to reach 180°F/82°C. If the wash cycle runs for longer than 6 minutes, contact a Service Agent.
Why is steam not being vented in my Champion Dishwasher Condensate Removal Option Model?
Steam may not be venting in your Champion Dishwasher Condensate Removal Option Model if the incoming cold water temperature is above 75°F/24°C or if the incoming water pressure is below 45 PSI flowing pressure at the dishwasher. Check both the incoming water temperature and pressure. If these are within the correct range, the condensate coil or fan may be defective, and you should contact a Service Agent.
Why is steam not being vented from my Champion Genesis DH5000T Direct Vent Option Model?
Steam not being vented from your Champion Dishwasher Direct Vent Option Model may be due to a blocked or defective direct vent fan. Contact a Service Agent or Building Maintenance for assistance.
Provides phone numbers and email for Champion's service departments in Canada and the USA.
Covers warranty periods, conditions, exclusions, and disclaimers for machines and parts.
Instructions for inspecting the unit upon arrival and positioning it correctly.
Procedures for connecting dish tables, electrical power, and water supply.
Explanation of the dishwasher's control panel, including buttons, displays, and indicators.
Step-by-step instructions for running both standard and heavy duty wash cycles.
A guide to diagnosing and resolving common problems encountered during dishwasher operation.
General| Brand | Champion |
|---|---|
| Model | Genesis DH5000T Series |
| Category | Dishwasher |
| Language | English |
To Next Page