If there is accumulated water on the ground after work, you can lift the brush plate, turn on the suction motor and then move
the machine forward and backward repeatedly in the working area until the water is removed. If there are deep grooves on the
ground, the accumulated water cannot be removed by the machine and can only be dealt with in other ways.
Note:
When the suction motor is abnormal during the work or the squeegee cannot work normally, stop the machine immediately and do
the following checks.
Check whether the sewage tank is filled. In this case, discharge the sewage tank immediately. If the sewage tank is not filled,
check whether the joint part of the squeegee is blocked, and remove the blockage immediately if this is the case.
If there is a great amount of foam in the sewage tank, add a certain amount of defoamer to the sewage tank.
3.4 Replacement of the brush plate
Put the brush plate to be installed under the brush plate cover and make sure that its head is aligned with the bayonet. Press
the brush plate motor button and the plate will be installed automatically with the rotation of the motor. The brush plate can
also be installed manually.
For inexperienced personnel, it is recommended to install the brush plate manually.
To Next Page
Loading...