To Next PageTo Next Page
Need help?Do you have a question about the Chapin 82108B and is the answer not in the manual?
Emphasizes reading and following all instructions before using the product to prevent failure or injuries.
Warns about product containing lead, known to cause birth defects and reproductive harm.
Prohibits operation by untrained persons or children; advises wearing protective gear.
Connects the handle bar components (C-8, C-9, C-11) to the main frame (C-5, C-7) using various hardware.
Continues assembly of handle parts, securing them with hardware for control mechanism.
Attaches the handle grips (H-9) to complete the handlebar assembly.
Attaches frame legs (H-8) to the hopper assembly (C-17) using hardware (H-5, H-7).
Connects support bars (C-12, C-13) and attaches the gear box (C-3) with correct orientation.
Mounts the wheels (C-1) to the spreader frame using hardware (H-4, H-7, H-11, H-6, H-3, H-2, H-1).
Attaches the handlebar assembly to the hopper frame using components like C-5, H-5, H-7.
Attaches the auger mechanism and involves specific hardware handling for steps 4.5-4.6.
Adjusts the gate mechanism, ensuring it closes properly when the lever is forward.
Tightens all assemblies after completing gate adjustment to secure the structure before use.
Wash spreader with a garden hose after each use to prevent rust, avoiding direct spray on gear box.
Avoid power washers, apply grease monthly to fittings, and check tire inflation to 20psi.
Provides conversion settings for Scotts and Chapin spreaders for various materials like weed control, fertilizer, and salt.
Illustrates a typical spread pattern, indicating start, stop, and restart points for even application.
General
