Char-Broil RED 463250108 User Manual (English)

Questions and Answers:

K
Kyle MoralesJul 30, 2025
How to fix Char-Broil RED 463250108 Grill burner not lighting with ignitor?
- H
  Heather MitchellJul 31, 2025
  If the burner on your Char-Broil Grill won't light using the ignitor, start by replacing the AA battery with a new alkaline one. If that doesn't work, inspect the electrode. Make sure the tip of the electrode is pointing towards the gas port opening on the burner, positioned about 1/8” to 1/4” away. Adjust if needed. Also, check for cracks or breaks in the electrode; if you see sparks at a crack, replace the electrode. Clean any cooking residue from the wire and electrode using rubbing alcohol and a clean swab. Ensure all wires are securely connected, and if they are shorting (sparking) between the ignitor and electrode, replace the ignitor wire/electrode assembly.
C
Charles JohnsonAug 7, 2025
What to do if Char-Broil RED 463250108 burner won't light and there's no gas?
- T
  tracimyersAug 7, 2025
  If the burner on your Char-Broil Grill won't light using the ignitor, make sure that the LP cylinder is not empty. If it’s not empty, there might be a vapor lock. To resolve this, turn off the knobs and disconnect the coupling nut from the LP cylinder, then reconnect and try again. Also, ensure the coupling nut and LP cylinder valve are fully connected by tightening the coupling nut approximately one-half to three-quarters additional turn until you reach a solid stop, tightening it by hand only.
M
Matthew RogersAug 14, 2025
Why won't my Char-Broil RED 463250108 Grill burner light with ignitor, even with gas?
- T
  Todd ScottAug 14, 2025
  If the burner on your Char-Broil Grill won't light using the ignitor, make sure the valves are correctly positioned inside the burner tubes. Also, check the burner tubes for obstructions like spider webs or other debris. Clean them as described in the cleaning section.
A
Anthony HoffmanAug 21, 2025
What to do if Char-Broil RED 463250108 ignitor wires are loose?
- D
  damonwilkinsonAug 22, 2025
  If the burner on your Char-Broil Grill won't light using the ignitor, check if the wires are loose or disconnected. Reconnect them, or replace the electrode/wire assembly if necessary.