Char-Griller 5650 - Before Use Checks; Leak Testing Procedure; Lighting Instructions

LP Gas & Charcoal Grill
35
5650/5072_OM_A1
BEFORE USE CHECK FOR LEAKS
NOTE: Before starting the grill, check for leaks. Make sure the regulator valve is securely fas-
tened to the burner and the cylinder to prevent re or explosion hazard when testing for a leak.
Always perform the “Leak Test” as described below before lighting the grill or each time the
cylinder is connected for use.
• Do not smoke or allow other sources of ignition in the area while conducting a leak test.
• Conduct leak test outdoors in a well-ventilated area.
• Do not use matches, lighters or a ame to check for leaks.
• Do not use grill until any and all leaks are corrected. If you are unable to stop a leak,
disconnect the propane supply. Call a gas appliance serviceman or your local propane gas
supplier.
Leak Test
1. Mix 2-3 . oz. of solution, 1 part dishwashing soap, 3 parts water.
2. Ensure control valve is closed.
3. Connect regulator to cylinder and valve to burner. Ensure connections are secure before
turning on gas.
4. Retest after xing leak.
5. Turn gas off after testing.
6. If leakage is detected and cannot be rectied, please call Char-Griller customer service at 912-
638-4724 or email at Service@CharGriller.com.
Lighting Instructions
Always open hood while igniting grill. If grill does not light, always wait 5 minutes for gas to clear
before relighting. Failure to do either may result in an explosive are-up, which can cause serious
bodily injury or death. Once lit, but before cooking on grill for rst time, let grill sit for 15 minutes
with hood closed. This heat cleans grill’s internal parts from anything they may have come into
contact with during manufacturing and shipping.
Main Burners
1. Make sure there are no obstructions of airow to gas unit. Spiders
and insects can nest within and clog the burner tube. A clogged
burner tube can lead to a re beneath appliance.
2. Make sure all burner knobs are in OFF position.
3. Open valve on LP gas cylinder.
4. To ignite a burner, push in and rotate knob to “HIGH,” then push and
hold Electronic Ignition Button until burner lights. If burner does not
light in 5 seconds, turn burner OFF, wait 5 minutes for gas to clear
and repeat procedure. Repeat for all desired burners. Light only
burners intended for use.
5. Adjust knobs to desired cooking setting.
Never check for leaks with a naked eye. Always use a soapy water solution.