24
Searing Main Burner and Side Burner
1. If you have already attempted to light the searing main burner or Side burner with the igniter, allow 5
minutes for any accumulated gas to dissipate.
2. Insert a match into the lighting rod as shown in Fig.27. Ignite the match and insert through the cooking
grids to the burner.
3. Push and turn the Searing or Rear Burner knob slowly to IGNITE/ON, hold in until the burner is lit.
Once it is lit, continue to press and hold for another 15 seconds to ensure the burner stays lit.
4. If burner does not light up, turn the knob off, wait 5 minutes and try again.
Rear Burner
Note: Remove the warming rack when using a match to light the rear burner.
1. If you have already attempted to light the rear burner with the igniter, allow 5 minutes for any
accumulated gas to dissipate.
2. Insert a match into the lighting rod as shown in Fig. 27. Ignite the match and hold next to the burner.
3. Push and slowly turn the Side Burner knob to IGNITE/HI position, the corresponding burners should
be lit immediately.
4.
If burner is not lit, turn the knob off, wait 5 minutes and try again.
Fig. 27
Main burner
Rear burner/Searing
Main burner
Side burner
To Next Page