28
1．Install the regulator hose (short hose) to the end of the regulator marked "OUT". Install the brass
connector to the other end of the regulator marked "IN." (If regulator, hose, and brass connector are pre-
assembled, you may disregard this step.)
2．Turn all knobs to OFF. Turn off LP gas supply and remove the LP cylinder from the grill cart. Remove
the brass adapter of the LP regulator from the manifold with a wrench.
3. Screw the NG regulator to the NG bracket with two 5/32-in. screw and two 5/32-in. locking washers.
4．Screw the NG bracket on the left side panel from inside the grill cart.
Main Tube Burner Conversion
Tools required:
Phillips Head Screwdriver (+)
To Next Page
Loading...
