30
6 mm nut driver
1. Loosen the igniter wire screws, searing main burner brace screws, and back two screws securing
searing side burners.
2. Take out the searing side burner from the firebox. Locate orifice on end of valve and remove by
turning counterclockwise with a 6mm nut driver.
3. Insert NG orifice with a 6mm nut driver and secure tightly by turning clockwise. Reinsert the searing
side burner.
Question Mark Burner Conversion
Tools required:
Phillips Head Screwdriver (+)
To Next Page
Loading...
