15 700 02 0319
Device Description
11
Cables and accessories other than those specied or supplied by the manufacturer
must not be used.
3.3 Unpacking the device
• Check that all items are included in the packaging container and that they are
not damaged.
• Remove the device and accessories from the packaging container. Proceed with
extreme caution.
• Contact your supplier or the manufacturer/dealer immediately if any items are
missing or damaged.
• Retain the original packaging. It may prove useful for any later equipment
transport.
A lm indicating that you must read the operating manual is afxed to the device
display.
• Read the operating manual and then remove the lm from the device.
3.4 Transport base plate
In order to protect it, the device is supplied mounted on a transport base plate,
which is secured with hook-and-loop tape. This must be removed before the device
is started up.
Removing the transport base plate
• This plate must be removed before the device is used for the rst time.
• Undo the hook-and-loop tape.
• Lift the device from the base plate (Fig. 3-3).
1
2
1 Hook-and-loop tape
2 Transport base plate
3
4
3 Ribs
4 Slits
Fig. 3-3 Removing the transport base plate
To Next Page
Loading...
Need help?
General
