6
BiT-2 Installation
Speaker and microphone installation
Two microphones for both open-face helmet and full-face helmet are provided.
Please choose the one that you intend to use for the type of your helmet.
Remove the inner pad of the helmet where you want to locate the speakers and
microphone.
Make sure to clean inside of your helmet with alcohol and fully dry the spot
where you want to put the Velcro for the speakers and microphone.
For open-face helmet, attach soft Velcro disk inside of the helmet at chic level
and place the boom-microphone on it. Additionally, x the boom-stick by using
the buttery shaped holder to support it.
For full-face helmet, attach soft Velcro disk on the chin bar of the helmet and
attach hard Velcro disk to the microphones.
Mount the soft Velcro disks on the liner of your helmet, in the indentation of the
helmet padding, where your ears would line up. For the best sound quality, be
sure to locate the speakers to the right location.
Attach the right speaker (with the longer wire) to the corresponding Velcro disk
that you applied on the helmet liner. Attach the left speaker (with the shorter
wire) to the other Velcro disk.
Re-install removed inner pad back on the helmet.
microphones more than one time may result in poor adhesion. (You
can purchase Velcro separately from our website.)
Installation of BiT-2 using cradle
Prepare the provided cradle, bracket, screws and L-wrench.
Attach the metal bracket to the cradle using screws but do not fully tighten at
this stage.
To Next Page
Loading...