What to do if Chauvet COLORado 1 Spotlight lamps cut off sporadically?
If the lamps cut off sporadically, it could be due to a bad lamp or the fixture overheating. Check the DMX and power cable connections.
What to do if Chauvet Spotlight fixture is not responding?
If the fixture isn't responding, check the DMX menu settings for correct addressing, inspect the DMX cables, and verify the polarity switch settings on the controller.
What to do if Chauvet Spotlight device has no power?
If the device has no power, first check for power on the Mains. Then, check the device’s fuse, both internal and external.
Why does my Chauvet Spotlight breaker/fuse keep blowing?
If the breaker or fuse keeps blowing, check the total load placed on the device.
How to fix loss of signal on Chauvet Spotlight?
To fix a loss of signal, use only DMX cables and install a terminator. Also, keep DMX cables separated from power cables or black lights.
What to do if Chauvet COLORado 1 light will not come on after power failure?
If the light will not come on after a power failure, check the fuse and check for power on Mains.
What to do if Chauvet COLORado 1 Spotlight fixture is on but there is no movement to the audio?
If the fixture is on but there is no movement to the audio, make sure you have the correct audio mode on the control switches. If audio is provided via a ¼” jack, ensure a live audio signal exists and adjust the sound sensitivity knob.
Why does my Chauvet COLORado 1 Spotlight auto shut off?
If the device auto shuts off, check the fan thermal switch reset.
Why is my Chauvet COLORado 1 beam very dim?
If the beam is very dim or not bright, clean the optical system or check the dimmer value.
Initial safety guidelines for fixture operation.
Key capabilities and functionalities of the fixture.
Step-by-step guide on how to replace the fixture's fuse.
Instructions for connecting multiple fixtures together.
How to use the control panel buttons and navigate menus.
Creating and editing custom light sequences.
Fixture operates automatically without external control.
Instructions for connecting and configuring the controller.
Creating user-defined light programs on the controller.
Power| operating voltage | 100V ~ 240V 50/60 Hz |
|---|---|
| fuse | 2A 250V |
| power consumption | 51.3W (0.56A at 120V) Max |
| inrush power | 45.6W (1.33A) at 120V |
| power factor | 0.72 at 120V |
| power output (daisy chain) | 20 units max at 110V, 40 units max at 230V |
Light Source| led | 36 x 1W (12 Red, 12 Green, 12 Blue) |
|---|---|
| refresh rate | 400Hz |
Photo Optic| illuminance at 1m (with included 15 degree lenses) | 1, 370 fc (14, 741 lux) |
|---|---|
| illuminance at 1m (with optional 15 degree lenses) | 385 fc (3, 414 lux) |
| beam angle (with included 15 degree lenses) | 11.6° |
| field angle (with included 15 degree lenses) | 24° |
| beam angle (with optional 30 degree lenses) | 24.8° |
| field angle (with optional 30 degree lenses) | 46.5° |
Operating Environment| maximum ambient temperature | 104°F (40°C) |
|---|---|
| ingress protection rating | IP66 |
Weight and Dimensions| length | 6.5 in (165 mm) |
|---|---|
| width | 9.5 in (240 mm) |
| height | 10 in (255 mm) |
| weight | 8.8 lbs (4 kg) |
To Next Page
