Before mounting this product, read the Safety Notes. Place launcher
level surface using the double brackets provided
or use a clamp to mount to
truss systems (such as TRUSST®). Always use at least one safety cable
Ensure that the launcher is not shooting directly into anyone’s face or
above heavy traffic areas.
When mounting overhead, be sure to point Funfetti™ at an
angle to keep the confetti from pouring out prior to launching.
This product has a voltage-specific power supply that can work with an input
voltage of 120 VAC, 60 Hz or 230 VAC, 50 Hz.
1. Disconnect the product from power.
2. Wedge the tip of a flat-head screwdriver into the slot of the fuse holder.
3. Pry the safety cap out of the housing.
4. Remove the blown fuse from the clip on the front of the safety cap and
replace with a fuse of the exact same type and rating.
5. Re-insert the fuse holder and reconnect power.
Disconnect the product from power before replacing the fuse.
Floor Mounting
(such as the CLP-15N
clamp from Chauvet)
To Next Page
Loading...
