Chauvet Funfetti - Operating the Funfetti; Filling and Powering On; Standalone Mode Control; FC-W Wireless Remote Control

Funfetti™ QRG EN
6
Operation
1. Fill the main tube with Funfetti™ refills (FRC, FRM, and FRU, sold
separately).
Note: The use of CHAUVET® Funfetti™ refills, specially
manufactured for use with Funfetti™ launchers, is recommended.
The standard tank capacity is: 0.5 lb (0.25 kg) for FRC and FRU;
1 lb (0.45 kg) for FRM.
2. Plug into a suitable power outlet.
3. Turn on the Funfetti™ by one of the following:
• Pressing the <MENU> and <ENTER> buttons at the same time.
• Using DMX activation.
• Pressing the button assigned to CH-1 on the FC-W wireless remote
control.
Note: To refill the Funfetti™ launcher, turn off the launcher and
add more Funfetti™ refill to the main tube.
Control from the
Display
Press the <MENU> and <ENTER> buttons at the same time
. This will
activate the Funfetti™ blower fan immediately. Press buttons again
to shut
off.
• The display will show d 1 while in this standalone mode.
• Set your DMX before loading Funfetti™ refills.
• The fan will blast confetti up to 30 ft (9 m) and run for 25 seconds.
FC-W Wireless
Remote Control
To trigger the Funfetti™ using the FC-W wireless remote control,
plug in the
product and do the following:
1. Plug the wireless receiver into the Wireless Remote
port on the side of the
Funfetti™.
2. On the wireless transmitter, press the button assigned to CH-1 (1–4) and
the Funfetti™ fan turns on.
For more information on the FC-
W or to download instructions, go to
http://www.chauvetlighting.com/product-manuals-literature/.