Configuring the Local Network
Quantum Spark 1500, 1600, and 1800 Appliances R81.10.X Locally Managed Administration Guide|86
For example, to monitor the traffic after the router, enter the IP address of the Default Gateway and
the 255.255.255.255 subnet.
9. Click Apply
The Internal network you defined (with Monitor Mode in the name) shows in the list of interfaces.
Note - You can configure multiple local networks to be in monitor mode at the same time.
After you configure monitor mode:
1. Go to Device > Advanced Settings.
2. Turn off Anti-Spoofing.
To configure monitor mode in Gaia Clish:
1. To define a port for Monitor Mode:
set interface <Port Name> monitor-mode
2. To configure Monitor Mode Automatic Learning, disable user-defined networks:
set monitor-mode-configuration use-defined-networks false
3. To configure Monitor Mode with user-defined networks:
add monitor-mode-network ipv4-address <IP Address> subnet-mask <Mask>
set monitor-mode-configuration use-defined-networks true
4. To see user-defined Internal networks:
show monitor-mode-network
5. To disable Anti-Spoofing:
set antispoofing advanced-settings global-activation false
To Next Page
Loading...
