Check Point QM-2 - User Manual

[Classification: Protected]
12 August 2020
6000 AND 7000
APPLIANCES
QS-15, QM-30, QS-2, QM-1, QM-2, QM-35
Getting Started Guide

Summary

Important Information

Latest Software Recommendations

Recommends installing the most recent software release for functional improvements and stability.

Safety, Environmental, and Electronic Emissions Notices

General Safety Warnings

Covers handling, static discharge, battery, and laser warnings for safe appliance operation.

Rack Mount Instructions

FCC Notice and RF Exposure Statement

Mounting the Appliances in a Rack

Appliance Physical Specifications

Configuring the Appliances

Starting the Appliance

Instructions on how to connect, power on, and begin configuring the appliance.

Synchronizing RAID on 6800, 6900, 7000

Monitoring RAID Status

RAID Status Monitoring via SmartConsole;SNMP

Hot Swapping Storage Devices

Initial Configuration

First Time Configuration Wizard

Guides users through the initial setup and configuration of the appliance.

Creating the Network Object

Security Gateway Object Setup

Advanced Configuration

Connecting to the Appliance CLI

Explains methods for establishing a command line interface connection to the appliance.

6000;7000 Appliances Hardware

Front Panel Overview

Front Panel Component Details

Front Panel Ports Identification

Front Panel System LEDs

Rear Panel Overview (6200 Base)

Rear Panel Overview (Other Models)

Rear Panel Component Details (7000 Series)

Rear Panel Component Details (Continued)

Using the Power Cable Restraint Strip on 6200 and 6400 Appliances

Power Cable Restraint Strip Installation

Power Cable Restraint Clip Usage (6500-7000)

Dual Redundant BIOS

BIOS Failure and Recovery

Replacing and Upgrading Components

Supported Replacement Parts

Restoring Factory Defaults

Restoring via Gaia Portal

Step-by-step guide to restore the appliance to factory defaults using the Gaia Portal interface.

Restoring via Boot Menu

Restoring from Gaia Clish

Gaia Clish Revert Command

Details the specific command to revert the appliance to factory defaults using Gaia Clish.

Check Point QM-2 Specifications

General

Brand	Check Point
Model	QM-2
Category	Network Hardware
Language	English