Wiring connection for gas cooker
To allow for disconnection of the appliance after installation,
the plug must be accessible after installation, or a functional switch
must be provided near the appliance in an accessible position.
If the supply cord is damaged, it must be replaced by the
manufacturer,itsserviceagentorsimilarlyqualiedpersons
in order to avoid a hazard.
Gas connection
Read these points before connecting to the gas supply:
• Thecookerinletconnectionpointhasa½”BSPexternal
thread. See Diagram below
• ANGregulatororaLPGtestpointttingissupplied
• Itisrecommendedtottheregulatorortestpointttingto
the appliance connection point, then fit either hard piping
orahighlevelexibleconnection(AS/NZS5601.1
clauses 5.9 and 6.10.1.9) which is then attached to the
consumer hard piping
• Ensureinstallationallowswithdrawalofappliance.
Restraining Device
Anchor Points
Gas
Connection Point
150mm
650mm
Operation on universal LPG/propane
1. The appliance inlet fitting provided MUST be orientated
so that the pressure nipple is accessible
2.Theinletttinghas½”BSPinternalthreadattheinlet
and outlet.
Operation on SNG
• IfthecookeristobeusedwithSNG,thenthegrillburner
MUST be modified by the replacement of the shutter,
which fits into the throat of the grill burner
• Aconversionkitcanbeobtainedbycontactingthe
Customer Care Centre
1. Disconnect electric power before removing control panel
2. Remove the control panel
3. Remove the existing NG shutter securing screw (refer to
diagram above) and slide upwards to disengage from
grill burner
4. Slide the SNG shutter into position and secure with screws.
Testing the gas cooker